Takeuchi TB014 Werkstatt-Handbuch Seite 386

SM-E2B SERIES, WSM
Fuel Tightness of Pump Element
1. Remove the engine stop solenoid.
2. Remove the injection pipes and glow plugs.
3. Install the injection pump pressure tester to the injection pump.
4. Install the injection nozzle (1) jetted with the proper injection
pressure to the injection pump pressure tester (2). (Refer to
the photo.)
5. Set the speed control lever to the maximum speed position.
6. Run the starter to increase the pressure.
7. If the pressure can not reach the allowable limit, replace the
pump with new one or repair with a Kubota-authorized pump
service shop.
Fuel tightness of pump
Allowable limit
element
A Never try to disassemble the injection pump assembly.
For repairs, you are strongly requested to contact a
Kubota-authorized pump service shop.
(1) Injection Nozzle
(2) Injection Pump Pressure Tester
S-22
DIESEL ENGINE
13.73 MPa
140
1991 psi
(3) Protection Cover for Jetted Fuel
0000001360E