Takeuchi TB014 Werkstatt-Handbuch Seite 397

SM-E2B SERIES, WSM
Nozzle Holder Assembly and Glow Plug
1. Remove the overflow pipe (1).
2. Remove the nozzle holder assemblies (2).
3. Remove the copper gasket (5) and the heat seal (6).
4. Remove the lead (3) from the glow plugs (4).
5. Remove the glow plugs (4).
(When reassembling)
A Replace the copper gasket and heat seal with new one.
Overflow pipe retaining
nut
Tightening torque Nozzle holder assembly
Glow plug
(1) Overflow Pipe
(2) Nozzle Holder Assembly
(3) Lead
Rocker Arm and Push Rod
1. Remove the rocker arm bracket screws (1).
2. Detach the rocker arm assembly (2).
3. Remove the push rods (3).
(When reassembling)
A When putting the push rods (3) onto the tappets (4), check to
see if their ends are properly engaged with the dimples.
A After installing the rocker arm, be sure to adjust the valve
clearance.
Rocker arm bracket
Tightening torque
screw
(1) Rocker Arm Bracket screws
(2) Rocker Arm Assembly
S-33
DIESEL ENGINE
19.6 to 24.5
2.0 to 2.5
14.5 to 18.1 ft-lbs
49.0 to 68.6
5.0 to 7.0
36.2 to 50.6 ft-lbs
7.85 to 14.7
0.8 to 1.5
5.8 to 10.8 ft-lbs
(4) Glow Plug
(5) Copper Gasket
(6) Heat Seal
0000008694E
9.8 to 11.3
1.00 to 1.15
7.2 to 8.3 ft-lbs
(3) Push Rod
(4) Tappet
0000008695E