Check Points Of Every 500 Hours - Takeuchi TB014 Werkstatt-Handbuch

SM-E2B SERIES, WSM

[6] CHECK POINTS OF EVERY 500 HOURS

Cleaning Fuel Tank Inside
Cleaning Water Jacket and Radiator Interior
A Do not remove the radiator cap when the engine is hot.
Then loosen cap slightly to the stop to relieve any excess
pressure before removing cap completely.
1. Stop the engine and let cool down.
2. To drain the coolant, open the radiator drain plug (2) and
remove the radiator cap (1). Then radiator cap (1) must be
removed to completely drain the coolant. And open the drain
cock (3).
3. After all coolant is drained, close the drain plug.
4. Fill with clean water and cooling system cleaner.
5. Follow directions of the cleaner instruction.
6. After flushing, fill with clean water and anti-freeze until the
coolant level is just below the port. Install the radiator cap (1)
securely.
7. Fill with coolant up to "FULL" (A) mark on the recovery tank
(4).
8. Start and operate the engine for few minutes.
9. Stop the engine and let cool. Check coolant level of radiator
and recovery tank (4) and add coolant if necessary.
A Do not start engine without coolant.
A Use clean, fresh, soft water and anti-freeze to fill the
radiator and recovery tank.
A When the anti-freeze is mixed with fresh, soft water, the
anti-freeze mixing ratio must be less than 50 %.
A Securely tighten radiator cap.
improperly fitted, water may leak out and the engine could
overheat.
(1) Radiator Cap
(2) Drain Plug
(3) Drain Cock
(4) Recovery Tank
G-13
GENERAL
0000001308E
If the cap is loose or
A : Full
B : Low
0000001309E