SM-E2B SERIES, WSM
Crankshaft Sleeve Wear (Z482-E2B, D662-E2B, D722-E2B,
D782-E2B)
1. Check the wear on the crankshaft sleeve.
2. If the wear exceeds the allowable limit or when the engine oil
leaks, replace the crankshaft sleeve.
Wear of sleeve
Allowable limit
Replacing Crankshaft Sleeve (Z482-E2B, D662-E2B, D722-E2B,
D782-E2B)
1. Remove the used crankshaft sleeve.
2. Set the sleeve guide (4) to the crankshaft.
3. Heat a new sleeve to a temperature between 150 and 200
(302 and 392
), and fix the sleeve to the crankshaft as
shown in figure.
4. Press fit the sleeve using the auxiliary socket for pushing (3)
(Code No. 07916-34041).
A Mount the sleeve with its largely chamfered surface
facing outward.
A Should heating is not enough, a sleeve might stop
halfway, so careful.
(1) Crankshaft Sleeve
(2) Crankshaft
S-76
DIESEL ENGINE
0.1 mm
0.004 in.
0000008714E
(3) Auxiliary Socket for Pushing
(4) Sleeve Guide
0000008715E