Herunterladen Inhalt Inhalt Diese Seite drucken

Inspection Every 500 Hours Or 6 Months; Fuel Filter - Takeuchi TB014 Werkstatt-Handbuch

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

2. Inspection and adjustment

2.2.5 Inspection every 500 hours or 6 months

Be sure to check the following points every 500 hours or 6 months operation, whichever comes first.
No.
(1)
Water separator cleaning
(2)
Fuel filter element replacement
(3)
Air cleaner cleaning and element replacement
(1) Air cleaner element replacement
The cup of an water separator is translucent, and the
inside can be seen. The float ring rises when water
collects at the bottom of the cup.
Periodically wash the water separator element and
inside cup with clean fuel oil.
1)Close the fuel cock.
2)Loosen the retaining ring and remove the cup. Take
the water and trash in the cup out.
3)Wash the element with clean fuel oil. Replace the
element with new one if any damaged.
Element Part No.
129335-55700
4)Insert the element to the bracket and put the float
ring and spring in the cup. Tighten the retaining ring.
Tightening torque: 13 to 16 N•m (1.3 to 1.6 kgf•m)
5)Bleed the fuel system. Refer to 2.2.3(3)
(2) Fuel filter element replacement
Replace the fuel filter element at specified intervals
before it is clogged with dust to adversely affect the fuel
flow. Do this work after an engine gets cold fully.
1)Close the fuel filter cock.
2)Loosen the retainer ring and replace the fuel filter
element. Take the water and trash in the cup out.
When removing the fuel filter, hold the bottom of the
fuel filter with a piece of rag to prevent the fuel oil
from dropping. If you spill fuel, wipe such spillage
carefully.
3)Install a new fuel filter element and tighten the
retainer ring.
Tightening torque: 13 to 16 N•m (1.3 to 1.6 kgf•m)
Fuel filter element Part No.
119740-55650
Inspection Item
28
Close
Air bleeding bolts
Outlet
Inlet
Loosening
Tightning
Fuel cock
Retaining ring
Fuel cock
Open
Water separator

Fuel filter

Mechanical
From water
Fuel feeding pump
separatr
Priming lever
Joint for fuel return
Close
Inlet
Loosening
Open
Fuel filter
Retaining
spring
Float ring
Fuel return hose
Fuel injection
pump
Outlet
Tightning
Retaining ring
Fuel cock

Quicklinks ausblenden:

Werbung

Kapitel

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Tb016

Inhaltsverzeichnis