External Components; Cylinder Head, Valves And Oil Pan - Takeuchi TB014 Werkstatt-Handbuch

SM-E2B SERIES, WSM

(2) External Components

(3) Cylinder Head, Valves and Oil Pan

Alternator, Starter and Others
1. Remove the air cleaner and muffler.
2. Remove the engine stop solenoid (1).
3. Remove the cooling fan (2), fan pulley and fan belt (3).
4. Remove the alternator.
5. Remove the starter.
(When reassembling)
A Check to see that there are no cracks on the belt surface.
A Keep the engine stop lever (5) to touch the stopper (4).
Tighten the engine stop solenoid mounting screw (6) so
that there be no gap between the engine stop lever and
the engine stop solenoid plunger (7).
A After reassembling the fan belt, be sure to adjust the fan
belt tension.
A Do not confuse the direction of the fan.
(1) Engine Stop Solenoid
(2) Cooling Fan
(3) Fan Belt
(4) Stopper
(5) Engine Stop Lever
Cylinder Head Cover
1. Remove the breather tube (1).
2. Remove the head cover screws (2).
3. Remove the cylinder head cover (3).
(When reassembling)
A Check to see if the cylinder head cover gasket is not defective.
Cylinder head cover
Tightening torque
screw
(1) Breather Tube
(2) Head Cover Screws
Injection Pipes
1. Loosen the screws on the pipe clamp (1).
2. Detach the injection pipes (2).
(When reassembling)
A Sent compressed air into the pipes to blow out dust. Then,
reassemble the pipes in the reverse order.
Injection pipe retaining
Tightening torque
nut
(1) Pipe Clamp
S-32
DIESEL ENGINE
(6) Engine Stop Solenoid Mounting
Screw
(7) Plunger
A : 0 mm (0 in.)
0000003304E
6.86 to 11.3
0.7 to 1.15
5.1 to 8.3 ft-lbs
(3) Cylinder Head Cover
0000008692E
24.5 to 34.3
2.5 to 3.5
18.1 to 25.3 ft-lbs
(2) Injection Pipe
0000008693E