Inspection - Takeuchi TB014 Werkstatt-Handbuch

9. Alternator

9.1.5 Inspection

(1) V belt inspection
4)Inspect the matter whether there are not crack, stick-
iness and wear on the belt visually.
Check that a belt doesn't touch the bottom part of the
pulley groove. If necessary, replace the V belt set.
5)V belt tension:
(Refer to 2.2.2.(2) in Chapter 2.)
(2) Visual check of wiring and check of
unusual sound
1)Confirm whether wiring is right or there is no loose-
ness of the terminal part.
2)Confirm that there is no unusual sound from the
alternator during the engine operation.
(3) Inspection of charge lamp circuit
1)Move a start switch to the position of on. Confirm
lighting of the charge lamp.
2)Start an engine, and confirm the lights-out of the
lamp. Repair a charge lamp circuit when a lamp
doesn't work.
Clearance
Inspection of V pulley
103
Normal Defect