Starter (Electromagnetic Drive Type) - Takeuchi TB014 Werkstatt-Handbuch

SM-E2B SERIES, WSM

(8) Starter (Electromagnetic Drive Type)

1. Unscrew the C terminal nut (6), and disconnect the connecting lead (11).
2. Unscrew the solenoid switch mounting nuts (1), and remove the solenoid switch (5).
3. Remove the end fream cap (16).
4. Remove the break shoe (15), break spring (14) and gasket (13).
5. Unscrew the through bolts (21), and remove the rear end frame (12).
6. Remove the brush from the brush holder while holding the spring up.
7. Remove the brush holder (20).
8. Draw out the yoke (18) from the starter drive housing (2).
9. Draw out the armature (9) with the drive lever (3).
A Do not damege to the brush and commutator.
(When reassembling)
A Apply grease (DENSO No. 50 or its equivalent) to the parts indicated in the figure.
- Joint of solenoid switch (a)
- Bushing (b)
- Drive lever (c)
- Collar (d)
- Teeth of pinion gear (e)
- Armature shaft (f)
Tightening torque C Terminal Nut
5.9 to 11.8 N-m
0.6 to 1.2
4.3 to 8.7 ft-lbs
S-52
DIESEL ENGINE
(1) Solenoid Switch mounting
Nut
(2) Starter Drive Housing
(3) Drive lever
(4) Gasket
(5) Solenoid Switch
(6) C Terminal Nut
(7) Snap Ring
(8) Overrunning Clutch
(9) Armature
(10) Brush Spring
(11) Connecting Lead
(12) Rear End Frame
(13) Gasket
(14) Break Spring
(15) Break Shoe
(16) End Frame Cap
(17) Screw
(18) Yoke
(19) Brush
(20) Brush Holder
(21) Through Bolt
0000005546E