Takeuchi TB014 Werkstatt-Handbuch Seite 428

SM-E2B SERIES, WSM
Camshaft Alignment
1. Support the camshaft with V blocks on the surface plate at
both end journals.
2. Set a dial indicator with its tip on the intermediate journal.
3. Measure the camshaft alignment.
4. If the measurement exceeds the allowable limit, replace the
camshaft.
Camshaft alignment Allowable limit
Cam Height
1. Measure the height of the cam at its highest point with an
outside micrometer.
2. If the measurement is less than the allowable limit, replace the
camshaft.
Factory spec.
Cam height of intake
and exhaust
Allowable limit
Oil Clearance of Camshaft Journal
1. Measure the camshaft journal O.D. with an outside
micrometer.
2. Measure the cylinder block bore I.D. for camshaft with a inside
micrometer, and calculate the oil clearance.
3. If the oil clearance exceeds the allowable limit, replace the
camshaft.
Factory spec.
Oil clearance of
camshaft journal
Allowable limit
Camshaft journal O.D. Factory spec.
Camshaft bearing I.D.
(Cylinder block bore Factory spec.
I.D.)
S-64
DIESEL ENGINE
0.01 mm
0.0004 in.
0000000891E
26.88 mm
1.0583 in.
26.83 mm
1.0563 in.
0000000892E
0.050 to 0.091 mm
0.00197 to 0.00358 in.
0.15 mm
0.0059 in.
32.934 to 32.950 mm
1.29661 to 1.29724 in.
33.000 to 33.025 mm
1.29921 to 1.30020 in.
0000001350E