Inspection Every 50 Hours - Takeuchi TB014 Werkstatt-Handbuch

2. Inspection and adjustment

2.2.3 Inspection every 50 hours

Be sure to check the following points every 50 hours operation.
No.
(1) Fuel tank draining
(2) Water separator draining
(3) Bleeding the fuel system
(4) Battery electrolyte level check and battery recharging
(1) Fuel tank draining
1)Prepare a waste oil container.
2)Remove the drain plug of the fuel tank to drain
(water, dust, etc.) from the fuel tank bottom.
3)Drain until fuel with no water and dust flow out. Then
tighten the drain plug firmly.
(2) Water separator draining
Drain off the water separator whenever there is a lot of
drain collected in the water separator at the bottom of
the cup even if not the time for periodic inspection hour.
The cup of the water separator is made from semi-
transparency material and in the cup, the red colored
float ring which rises on the surface of the drain is
installed to visualize the amount of drain.
Drain off the water separator in the following manner.
1)Close the fuel cock.
2)Loosen the retainer ring, and remove the cup, then
throw collected water and trash away.
3)Put a float ring and a spring in the cup, and tighten
the retainer ring.
Tightening torque: 13-16 N•m (1.3-1.6 kgf•m)
4)Be sure to bleed air in the fuel system.
Inspection Item
22
Fuel tank
(OPTION)
Drain plug
Close
Air bleeding bolts
Outlet
Inlet
Loosening
Tightning
Fuel cock
Retaining ring
Fuel cock
Open
Water separator
Retaining
spring
Float ring