Measuring Programs - Bosch MOT 240 Bedienungsanleitung

4.

Measuring programs

Approximately 15 seconds after being turned on, the MOT is
ready to operate. This is indicated by the basic image with system
message and the appearance of the motor type stored at memory
location "1" on the display.
Basic image with system message after actuation
Basic picture without system display after the return (with the hardkey
„Return" O) e.g.: out of the measuring program „engine test".
The selection of the corresponding measuring program can be
carried out if the engine type, selected or indicated, corresponds
to the vehicle to be tested. In other case, you must introduce in
first the correct engine type (see section 4.6). Moreover, from this
display, you can select the setting of basic functions of the
Motortester.
F1: Engine test (4.1)
F2: Multitest (4.2)
F3: Injection test (4.3)
F4: Exhaust-gas test/Exhaust-gas analysis (4.4)
F5: Setting the engine-specific data (4.6)
F6: MOT - Basic adjustments (6.)
67