Bosch MOT 240 Bedienungsanleitung Seite 62

Plug-in socket 1: Oil temperature sensor
No. Designation
1. 15-pin sensor
connector
2. Measuring sensor
3. Conical nipple
Plug-in socket 2: Multi-measuring cable with one red and one
black multi-clip for measuring voltages, resistance, injection time
in the test program multi-test and injection test and also for
oscilloscope measurements.
Remarks:
The black multi-clip is only required for the resistance measure-
ment and measurements of voltage without potential. All other
measurements, including all oscilloscope measurements, are
measured to the terminal B- (vehicle ground).
No. Designation
1. 15-pin sensor
connector
2. Banana plug
3. Measuring prods
4. Measuring clamps
62
Application
Connect to plug-in socket 1
Insert into hole for oil dipstick
Adjust the length, seal the
measuring point
Application
Connection to plug-in socket 2
Varies in accordance with
measuring point and test
program
Varies in accordance with
measuring point and test
program
Plug-in socket 2: Voltage divider 1 687 224 814 for oscillo-
scope measurements (5:1) (this voltage divider is a special
accessory and must be ordered separately). It is used to measure
voltage with the oscillogram to vehicle ground (terminal B-) in
case of signals higher than 40 V to max. 200 V (e.g. for sensor
signals at elevated rpm). For the measurement, use suitable
measuring prod to connect banana plug to the measuring point.
No. Designation
1. 15-pin sensor
connector
2. Banana plug
3. Measuring prods
4. Measuring clamps
Application
Connection to plug-in socket 2
Varies in accordance with
measuring point
Varies in accordance with
measuring point