Scheppach HS254 Originalbetriebsanleitung Seite 49

Attention: According to the German Product Liability
Act, no liability is accepted for damage caused by im-
proper repairs or by not using original spare parts.
Such work should be performed by a customer service
centre or an authorised specialist. The same applies to
accessory parts.
Spare parts and accessories can be obtained from our
Service Centre. To do this, scan the QR code on the
front page.
Connections and repairs
Connections and repair work on the electrical equipment
may only be carried out by electricians.
Please provide the following information in the event of
any queries:
• Type of current for the motor
• Machine data - type plate
• Motor data - type plate
15.1 Ordering spare parts
Please provide the following information when ordering
spare parts:
• Model designation
• Item number
• Type plate data
Spare parts / accessories
Saw blade
Table inlay
Push stick
Carbon brushes
15.2 Service information
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consumables.
Wearing parts*: Carbon brushes, table inlay, push stick,
saw blade
* may not be included in the scope of delivery!
16. Storage
m
WARNING
Risk of injury due to unexpected start-up of the machine
- Pull the mains plug out of the outlet.
ATTENTION
Product damage due to incorrect storage
- Store the product protected against dirt, dust and
moisture.
- Store the product in the original packaging.
1. Store the product in a dark, dry and frost-free place
that is inaccessible to unauthorised persons.
2. The optimum storage temperature lies between 5°C
and 30°C.
3. Store the operating manual with the product.
4. You can store the saw blade (3) and the two ring
spanners (D and E) in the storage space provided
(26) (Fig. 6).
17. Electrical connection
The electrical motor installed is connected and
ready for operation. The connection complies with
the applicable VDE and DIN provisions. The custom-
er's mains connection as well as the extension ca-
bles used must also comply with these regulations.
• The product fulfils the requirements of EN 61000-
3-11 and is subject to special connection require-
ments. This means that use at any freely selectable
connection points is not permitted.
• The product can cause temporary voltage fluctua-
tions in unfavourable mains conditions.
• The product is only intended for use at connection
Article no. points that
3901203703 a) do not exceed a maximum permissible mains im-
5901313036 pedance "Z" (Zmax. = 0,292 Ω), or
5901313021 b) have a mains constant current carrying capacity
5901308021 of at least 100 A per phase.
• As the user, you are required to ensure that the con-
nection point at which you wish to operate the prod-
uct fulfils one of the requirements mentioned, a) or
b). If necessary, consult with your energy supplier
in this regard.
17.1 Damaged electrical connection cable
The insulation on electrical connection cables is often
damaged.
This may have the following causes:
• Pressure points, where connection cables are passed
through windows or doors
• Kinks where the connection cable has been improper-
ly fastened or routed
www.scheppach.com GB | 49