Scheppach HS254 Originalbetriebsanleitung Seite 47

m WARNING
Risk of injury due to unexpected start-up of the machine
- Pull the mains plug out of the outlet.
12.1 Clean the product and saw blade guard
ATTENTION
Product damage due to inadequate cleaning
- Clean the product thoroughly after each use.
ATTENTION
Product damage due to aggressive solvents or cleaning
agents
- Remove coarse dirt with a brush.
- Clean the product with a damp, clean, lint-free
cloth and a little soft soap.
1. Remove dust and chips with a brush after each op-
eration.
2. Clean the ventilation openings carefully with a lint-
free cloth.
12.2 Clean product with compressed air
ATTENTION
Product damage due to the use of excessive pressure
on the compressed air device
Cleaning the product with high pressure from the com-
pressed air device can damage electrical components.
- Use a compressed air device with a low pressure
of max. 2 bar.
1. Ensure a suitable distance from the product.
2. Remove heavy soiling with a compressed air device
(max. 2 bar).
12.3 Cleaning the chip extraction system
The chip extraction system is not included in the scope
of delivery. To clean your chip extraction system prop-
erly, follow the operating instructions of the respective
manufacturer.
13. Transport
m WARNING
Risk of injury due to unexpected start-up of the machine
- Pull the mains plug out of the outlet.
13.1 General information
• Do not carry the product by the table width extensions
(7), but by the saw table itself (4).
• Pack the product to avoid damage during transport.
Use the original packaging.
• Protect the product from vibrations and shocks, in
particular during vehicular transport.
• Ensure adequate load securing when transporting in
a vehicle.
13.2 Product-specific information
1. When lifting the product, note its weight (see tech-
nical data).
2. Always switch off the electrical tool before transport
and disconnect it from the power supply.
3. Always carry the electric tool with at least one other
person, do not carry by the table width extensions.
To transport the electric tool, lift it by the machine
housing.
4. Protect the electrical tool from impacts, shocks and
severe vibrations, e.g. during vehicular transport.
5. Secure the electric tool against toppling and slip-
ping.
6. Never use protective devices for handling or trans-
port.
14. Maintenance
m
WARNING
Risk of injury due to unexpected start-up of the machine
- Pull the mains plug out of the outlet.
m
WARNING
Warning of unforeseeable hazards and product damage
- Never carry out unauthorised modifications or re-
pairs to the product that are not described in the
operating instructions.
- Do not carry out work described for a specialist
workshop.
14.1 General information
• Check the product for loose, worn or damaged com-
ponents.
• Check the nuts, pins and screws for firm seating.
• Check the covers and protective equipment for dam-
age and correct seating.
• Check the electrical connections. Repair work on the
electrical connections may only be carried out by a
specialist workshop.
14.2 Oiling the product
1. Oil the rotating parts once monthly to extend the life
of the tool.
2. Do not oil the motor.
www.scheppach.com GB | 47