Setting The Maximum Speed - Reely Speedy Bedienungsanleitung

If the throttle/brake lever is pulled directly from forwards to reverse at one stroke, the brake function of the drive will
be activated (the vehicle does not travel backwards).
In the event of an immediate switch from forwards to reverse, the throttle/brake lever must first be pushed away from
the handle and then moved to the neutral position (if the vehicle moves forwards during this phase, braking is also
activated as a result). If the throttle/brake lever is pushed away from the handle a second time, the vehicle drives in
reverse.
After driving forwards, the vehicle only drives in reverse if the throttle/brake lever is pushed away from the
handle a second time. This is required by the brake function; in addition, it protects the drive mechanism
from overload due to an immediate switch from forwards to reverse.
If the vehicle shows a tendency to move to one side, adjust the steering trim on the transmitter accordingly.
Discontinue use immediately if the vehicle does not respond as expected, or if the vehicle stops responding to the
transmitter commands. If this occurs, the drive battery, transmitter batteries/rechargeable batteries may be nearly
empty, or the vehicle may be too far from the transmitter.
A damaged receiver antenna, interference on the wireless channel (e.g. from other devices, Bluetooth
poor reception/transmission conditions may cause the vehicle to respond incorrectly.
The receiver is powered by the speed controller/drive battery; therefore, the vehicle may not move correctly when the
drive battery is nearly empty (e.g. the steering servo may not work properly).
For example, the drive battery voltage may drop momentarily at full throttle, and therefore the receiver may not re-
ceive the required voltage. If this occurs, the vehicle will accelerate, but the steering servo will not respond correctly.
Discontinue use immediately and use a new, fully charged drive battery.
If the drive battery is empty, wait for at least 5–10 minutes until the motor and speed controller have cooled down. You
can then use the vehicle again with a fully charged drive battery.
h) Setting the maximum speed
Use the left rotary control (6) on the transmitter to set the maximum speed of the vehicle.
• Turn the rotary control to the right (clockwise): increase maximum speed
• Turn the rotary control to the left (counter-clockwise): decrease maximum speed
For example, beginners can use this option to decrease speed.
If you turn the rotary control to the left, the vehicle may not move. In this case, turn the rotary control a bit
to the right (clockwise).
36
or Wi-Fi) or
®