Gerät Für Diagnose Vorbereiten - Metrohm Titroprocessor 796 Gebrauchsanweisung

13.1.2 Gerät für Diagnose vorbereiten
1. Netz aus.
2. Alle Kabel an der Rückwand, ausser Netzkabel entfernen.
3. Netz ein.
4. <Konfig.>
5. <
6. <Service diagn.>
Kap. 13.1.3 Kap. 13.1.3
Kap. 13.1.4 Kap. 13.1.4 + + 13.1.5 13.1.5
Kap. 13.1.6 Kap. 13.1.6
Kap. 13.1.7 Kap. 13.1.7
Kap. 13.1.8 Kap. 13.1.8
1)
Kap. 13.1.9 Kap. 13.1.9+ + 13.1.10 13.1.10
Kap. Kap. 13.1.11 13.1.11
1)
1)
1)
1)
1)
1)
1)
1) Dieser Diagnoseschritt ist dem Servicetechniker vorbehalten und wird daher in diesem Dokument nicht beschrieben.
Titroprocessor 796, Gebrauchsanweisung
>>
>
>>
1)
DIAGNOSIS WINDOW
S E R V I C E
! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! !
Choose diagnosis program by number or with softkey.
Programs can be quit with key <QUIT> or continued by key <ENTER>.
<f1> LCD environment (controller, CRT-RAM..)
<f2> Keyboard tests
<f3> Internal thermoprinter
<f4> Control lines
<f5> RS232 Interface 1/2
<f6> EBUS test, active EBUS loopback connector required
<f7> Analog Inputs A/B, adjust and test
<f8> Dosimats interface test
LCD Keybd. Thermo-
env. tests print.
DIAGNOSIS WINDOW
S E R V I C E
! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! !
Choose diagnosis program by number or with softkey.
Programs can be quit with key <QUIT> or continued with key <ENTER>
<f1> Memory and Data card tests
<f2> Small debugger
<f3> Data dumps
<f4> Show bookkeeping of power load
<f5> Enable/Disable early float.point traps in arithmetic
<f6>
<f7> Servicing notes
<f8> Factory delivering test sequence
Within arithmetic set float.point error to: error Message
MEM. & Small Data
Datacrd Debugg. Dumps
D I A G N O S I S
Control RS232 EBUS
lines interf. tests
D I A G N O S I S
Show Toggle
p.Load fp.trps
13. Anhang
Quit
Analog Dosimat >>
interf. interf. >>
Quit
Service Factory >>
notes tst.seq >>
261