Overview Compressed Air Regulator; Installing The Pneumatic Hose - VHF K5+ Originalbetriebsanleitung

EN 20

5.6.1 Overview compressed air regulator

The machine is connected to the external air supply via
a compressed air regulator. You can use this regulator
to monitor and regulate the pressure of the incoming
air.
The compressed air regulator is supplied with the
machine and needs to be mounted on the side of the
machine housing when installing the machine. The
regulator has the following connections:
1/8" internal thread, fitted with male compressed
n
air connector to connect the external compressed
air supply
6 mm push-in fitting to connect the machine.
n
Failure of the water separator
NOTICE
caused by a wrong alignment
of the compressed air regulator
The compressed air regulator must always be
mounted in an upright position because otherwise
the water separator will not work.
Mount the compressed air regulator in an upright
position.
On the left side of the machine are two bores which
you can use to mount the compressed air regulator on
the machine.
Mount the compressed air regulator in an upright
position, using the oval-head screws provided in the
bores.
F . 12 M
IG OUNTING THE COMPRESSED AIR REGULATOR

5.6.2 Installing the pneumatic hose

F
Original Operating Instructions: K5+
Version: 12/16/2021
K5+ – Installing the machine
. 13 I
IG NSTALLING THE PNEUMATIC HOSE
1. Close the external compressed air supply valve.
2. Use the provided pneumatic hose to connect the
right pneumatic connection of the compressed air
regulator to the pneumatic connection of the
machine.
3. Connect the external compressed air supply to the
left pneumatic connection of the compressed air
regulator.
4. Thoroughly verify that all external pneumatic hoses
are properly seated in their corresponding con-
nections and that the hoses and connectors are
undamaged.
5. If all hoses and connectors are properly installed
and undamaged, open the external compressed air
supply valve.