Removal And Installation Using A Hand Pallet Truck With Snapfit Battery Holder (O) - Jungheinrich EFG 213 Betriebsanleitung

5.3 Removal and installation using a hand pallet truck with Snapfit
battery holder (o)
CAUTION!
Trapping hazard
Trapping hazard when replacing the battery.
When replacing the battery do not reach between the battery and the chassis.
Wear safety shoes.
Removing the battery
Requirements
– Truck parked securely, (see "Parking the truck securely" on page 99).
– Battery exposed, (see "Exposing the battery"
on page 50).
Tools and Material Required
– Battery trolley with four rollers
– Hand pallet truck with Snapfit battery holder
– Charging station intended for the battery
type (60) (o)
Procedure
•
• Close the safety catch (55).
• To do this press the pedals (56).
• Fully lower the hand pallet truck.
• Move the hand pallet truck up to the centre of
the battery until Snapfit contacts the truck
chassis.
•
• Raise the forks of the hand pallet truck until the
recess (66) is exposed.
• Move the hand pallet truck into the battery
compartment until the safety catches lock the
battery trolley.
• Make sure both safety catches (55) are
securely
replacement trolley.
62
engaged in the
60
55
56
battery
66
56