Jungheinrich EFG 213 Betriebsanleitung Seite 170

Sideshifter
Hydraulic operations
Check attachment is properly secured to the truck and the
1
supporting elements.
Attachment: check bearing points, guides and stops for wear and
2
damage, grease and clean these components.
3 Test the sideshifter, check settings and check for damage.
4 Check cylinder piston rods and bushings.
5 Test attachment, check settings and check for damage.
6 Check cylinder seals.
7 Check sliding blocks are complete.
8 Check axial play of the front and rear rollers and adjust if necessary.
9 Check hydraulic ports and tighten if necessary.
10 Attachment: clean and lubricate.
Seat heating
Electrical system
Check electric wiring for damage [insulation damage, connections].
1
Make sure wire connections are secure.
Road traffic approval (StVZO)
Electrical system
1 Test lighting.
Telescopic forks
Hydraulic operations
1 Attachment: clean and lubricate.
2 Check hydraulic ports and tighten if necessary.
3 Check cylinder seals.
4 Test attachment, check settings and check for damage.
Check that hydraulic ports, hose and pipe lines are secure, check for
5
leaks and damage.
Check piston and piston rod for damage, check setting and adjust if
6
necessary.
Attachment: check bearing points, guides and stops for wear and
7
damage, grease and clean these components.
Check attachment is properly secured to the truck and the
8
supporting elements.
W A B C
t
t
t
t
t
t
t
t
t
t
W A B C
t
W A B C
t
W A B C
t
t
t
t
t
t
t
t
167