Parameter Settings - Jungheinrich EFG 213 Betriebsanleitung

Switching the truck off
Procedure
• Press the O key.
The truck is switched off.
Z
The truck can switch off automatically after a set time. To do this the relevant code
lock parameters must be entered, (see "Parameter Settings" on page 129). This
additional safety mechanism in no way discharges the owner from his obligation to
prevent the truck from being used by unauthorized parties before leaving the truck.
The owner must therefore apply the power-down key each time the truck is left.

6.1.2 Parameter Settings

To change the access code you must enter the master code.
Z
The master code factory setting is 7-2-9-5. Change the master code the first time
you use the truck.
Changing the truck settings
Procedure
• Press the O key (146).
• Enter the master code.
• Enter the three-digit parameter number.
• Confirm with the SET key (102).
• Enter the setting as per parameter list.
Z
If the entry is incorrect, the LED (147) of the O key (146) turns red.
• Enter the parameter number again.
• Enter the setting again or change it.
• Confirm with the SET key (102).
• Repeat the procedure for other parameters.
• Then press the O key (146).
The settings are now saved.
129