Removal And Installation Using An Eje Pallet Truck With Snapfit Battery Holder (O) - Jungheinrich EFG 213 Betriebsanleitung

5.2 Removal and installation using an EJE pallet truck with Snapfit
battery holder (o)
CAUTION!
Trapping hazard
Trapping hazard when replacing the battery.
When replacing the battery do not reach between the battery and the chassis.
Wear safety shoes.
Removing the battery
Requirements
– Truck parked securely, (see "Parking the truck securely" on page 99).
– Battery exposed, (see "Exposing the battery"
on page 50).
Tools and Material Required
– Battery trolley with four rollers
– EJE pallet truck with Snapfit battery holder
– Charging station intended for the battery
type (60) (o)
Procedure
•
• Close the safety catch (55).
• To do this press the pedals (56).
• Bring the EJE pallet truck approx. 200 mm
underneath the truck so that it is central with
the battery.
• Raise the forks of the EJE pallet truck until
they are just under the base of the truck.
•
• Push the ramps (61) into the plate recess and
align them with the chassis (62).
• Bring the EJE pallet truck up to the battery at
slow speed.
60
55 56
61
62 62
59