4.2
Charging the battery with an on-board charger
NOTE
Improper use of the on-board charger can cause material damage.
The on-board charger consisting of a battery charger and battery controller must not
be opened. For faults, contact the manufacturer's service department.
The charger must only be used for batteries supplied by Jungheinrich or other
approved batteries provided it has been adapted by the manufacturer's service
department.
Batteries must never be swapped from truck to truck.
Do not connect the battery to two chargers simultaneously.
Mains connection
The mains lead may vary depending on the size of the on-board charger.
– On-board charger with 65 Ah: 16 A; 230 V; 3 pin
– On-board charger with 130 Ah: 16 A; 400 V; 5 pin
DANGER!
Risk of electric shock and burning
Damaged and unsuitable wires can cause electric shocks and can overheat, resulting
in fires.
Only use mains cables with a maximum length of 30 m.
Fully unreel the cable reel when using it.
Always use original manufacturer's mains cables.
Insulation safety, acid and caustic ratings must comply with the manufacturer's
mains cable.
52