6.6
Panel door
CAUTION!
An open door can cause accidents
(148)
Do not travel with an open door (148).
When opening the door make sure there
is nobody in the door's swing range.
Always close the door tightly and make
sure it is locked.
Closing the door does not release the
driver from his responsibility to wear a
seat belt, (see "Seat Belt" on page 94).
Requirements
– On trucks with a door monitoring sensor, travel
is only enabled when the panel door is closed (o).
Procedure
• Pull the handle (152) towards the operator position, the door swings open.
• Pull the door (148) towards the driver; the door closes.
6.7
Operator position extension
DANGER!
Altering the tilt resistance can be dangerous
The lateral tilt resistance reduces with a higher truck centre of gravity.
The height above the overhead guardincreases by 300 mm.
Adapt the travel speed, in particular when cornering.
Z
For entry and exit (see "Entry and exit" on page 89).
136
152
148