Removable Load Backrest; Lift Cutout Override - Jungheinrich EFG 213 Betriebsanleitung

6.10 Removable load backrest

CAUTION!
Trapping hazard and heavy load backrest weight
Wear safety gloves and safety shoes when carrying out this operation.
Two people are required to remove and attach the load backrest.
Load backrest disassembly
Procedure
• Loosen the screws (160)
• Remove the load backrest from the fork
carriage and put it down securely.
Load backrest assembly
Procedure
• Attach the load backrest to the top rail of the fork carriage.
• Fit the bolts and tighten them with a torque wrench.
Z
Torque = 85 Nm

6.11 Lift cutout override

Z
A lift cutout device can be factory fitted when working in areas of restricted height.
This interrupts lifting.
To continue lifting:
Procedure
• Press the lift cutout override button ((see
"Armrest control panel switch (o)" on
page 82) or (see "Side compartment control
panel switch (o)" on page 83)).
• Pull the control lever (135): Lift cutout is
deactivated.
Z
Lift cutout is re-activated each time the mast
falls below the lift cutout height.
135
S
H
160
139