Jungheinrich EFG 213 Betriebsanleitung Seite 181

Clamping device
Hydraulic operations
1 Attachment: clean and lubricate.
2 Check hydraulic ports and tighten if necessary.
3 Check axial play of the front and rear rollers and adjust if necessary.
4 Check sliding blocks are complete.
5 Check cylinder seals.
6 Test attachment, check settings and check for damage.
7 Test the acknowledgement key.
8 Check cylinder piston rods and bushings.
Attachment: check bearing points, guides and stops for wear and
9
damage, grease and clean these components.
Check attachment is properly secured to the truck and the
10
supporting elements.
Crane hook
Hydraulic operations
Check attachment is properly secured to the truck and the
1
supporting elements.
Load backrest
Hydraulic operations
1 Check the load backrest for damage and make sure it is secure.
Safety restraint system / SUN protector
Electrical system
Check electric wiring for damage [insulation damage, connections].
1
Make sure wire connections are secure.
Chassis and superstructure
Make sure restraint system is complete, test operation and check for
1
damage.
2 Test restraint system sensor system and check for damage.
3 Check electrical connections are secure and not damaged.
4 Test travel cutout function.
Safety restraint system / SUN protector
Chassis and superstructure
Make sure restraint system is complete, test operation and check for
1
damage.
178
W A B C
t
t
t
t
t
t
t
t
t
t
W A B C
t
W A B C
t
W A B C
t
W A B C
t
t
t
t
W A B C
t