Settings
68
10.4.2 Frequency / Analog output
Fig. 10.25 Frequency/analog output
The Frequency/analog output menu can be used to
change the center frequency (torque output frequency) of
the stator output connector 1. The number of center fre
quency changes is stored in the stator. The number of
changes can therefore be seen in the counter. Possible
settings of the output frequency:
10 ±5 kHz = 0 Nm ± nominal (rated) torque
60 ±30 kHz = 0 Nm ± nominal (rated) torque
240 ±120 kHz = 0 Nm ± nominal (rated) torque
The change is implemented by pressing the Save key.
A4341-2.0 HBM: public
TIM-PN