Parameter Save/Load - HBM TIM-PN Montageanleitung

Settings
34

10.2.2 Parameter Save/Load

Fig. 10.6 Save and load parameters
You can save and load various settings in 32 parameter
sets in the interface module and reset all settings to the
factory default.
If you need more than 32 parameter sets, they must be
saved as a complete block. All parameter sets ex factory
are flagged to indicate that they have not yet been saved.
They cannot therefore be selected via PROFINET. Only
parameter sets that have explicitly been saved at least 1
time and therefore declared valid can then be selected
via PROFINET.
There are 32 parameter sets, 1 factory default parameter
set (read only) and a working parameter set. The working
A4341-2.0 HBM: public
TIM-PN