Configuring The Tim-Pn Module - HBM TIM-PN Montageanleitung

PROFINET configuration with the TIA portal
94

12.5 Configuring the TIM-PN module

All the torque-dependent process data are transferred in
the Torque module. You need the Speed module if you
are using a torque transducer with a rotational speed
module. All the speed-dependent process data are trans­
ferred in this module. The graphic below shows an over­
view of the two modules:
Take the following steps to create the required modules:
► Open the Device overview of the TIM-PN.
► In the Hardware catalog, open the Head modules
and Module folders.
In the standard configuration, the Torque module is
added in slot 1.
You need the Speed module if a speed sensor is present.
► Use drag & drop to move the speed module to slot 2.
A4341-2.0 HBM: public
TIM-PN