HBM TIM-PN Montageanleitung Seite 37

Settings
parameter set contains data from the active data parame­
ter set and data that are e.g. not explicitly shown in a
parameter set, for instance the network settings.
Working parameter sets can be saved in any one of the
32 parameter sets or overwritten by loading one of the 32
parameter sets or the factory default parameter set.
It is possible to load a parameter set either via the web
browser or via PROFINET. Apart from the working
parameter set, the actual settings can also be described
by further non-parameter specific settings (working data).
This includes, for instance, the network or linearization
settings.
Any changes that are not explicitly saved are rejected
and not saved when exiting a page. This means that the
old values of the actual working parameter set and the
working data are used next time that page is called.
(file name TIM-PN).
Click on the link Configuration file and confirm the
download into a directory of your choice.
Notice
Settings in TIM-PN are only saved when they are saved
in a parameter set or in the device. Otherwise the set­
tings will be lost after switch off.
The following parameters are saved in a parameter set.
All data from:
S 3.3 Units/filters
S 4.3 Speed transducer
All other data are saved in TIM-PN.
TIM-PN 35
A4341-2.0 HBM: public