Stryker 1089 Bedienungsanleitung Seite 30

C C l l e e a a n n i i n n g g
C C l l e e a a n n i i n n g g t t h h e e p p r r o o d d u u c c t t
W W A A R R N N I I N N G G - - Do not clean, service, or perform maintenance while the product is in use.
Recommended cleaning method:
1. Follow the cleaning solution manufacturer's dilution recommendations.
2. Hand wash all surfaces of the product with warm water and mild detergent.
3. Avoid over-saturation and make sure that the product does not stay wet longer than the detergent manufacturer's
guidelines for proper cleaning.
4. Dry thoroughly. Do not replace the mattress on the product until the product is dry.
5. Check functionality before you return the product to service.
• Raise and lower the product
• Lock and unlock the brake/steer pedal in both positions
• Latch and unlatch the siderails
• Raise and lower the Fowler backrest
• Raise and lower the Gatch
• Make sure all components have proper lubrication
• Make sure all labels are intact
N N o o t t e e
• Direct skin contact with visibly soiled, permeable material may increase the risk of infection.
• Some cleaning agents are corrosive in nature and may cause damage to the product if you use them improperly. If
you do not properly rinse and dry the product, a corrosive residue may be left on the surface of the product that could
cause premature corrosion of critical components. Failure to follow these cleaning instructions may void your
warranty.
• Do not steam clean, power wash, hose off, or ultrasonically clean the product. Use of these methods of cleaning is
not recommended and may void the product's warranty.
• Clean the base hood.
• Clean the bottom of the brake pads to prevent wax or floor remnant buildup.
C C l l e e a a n n i i n n g g t t h h e e m m a a t t t t r r e e s s s s
W W A A R R N N I I N N G G
• Do not clean, service, or perform maintenance while the product is in use.
• Do not immerse the mattress in cleaning or disinfectant solutions. Excess moisture could cause product malfunction that
results in product damage or patient injury.
• Do not allow fluid to pool on the mattress. Fluids can cause corrosion of components and may cause the safety and
performance of this product to become unpredictable.
• Always inspect mattress covers for tears, punctures, excessive wear, and misaligned zippers every time you clean the
covers. Remove and replace a damaged mattress to prevent cross-contamination.
• Do not steam clean, pressure wash, hose off, or ultrasonically clean mattresses. These methods of cleaning may void
the product's warranty.
The life of the mattress can be affected by an increase in frequency of usage, which might include more frequent cleaning
and disinfection.
EN 26 1089-109-005 Rev AA.0