Stryker 1089 Bedienungsanleitung Seite 19

T T r r a a n n s s f f e e r r r r i i n n g g a a p p a a t t i i e e n n t t w w i i t t h h t t h h e e p p a a t t i i e e n n t t t t r r a a n n s s f f e e r r b b o o a a r r d d
W W A A R R N N I I N N G G
• Always apply the brakes on both the product with the patient and the product the patient will be transferred to before you
transfer a patient from one patient support platform (bed, stretcher, gurney, operating table) to another patient support
platform.
• Always make sure that the patient support platforms are the same height before you transfer a patient.
• Always make sure that the transfer board is secure on both patient support platforms.
To transfer a patient with a patient transfer board:
1. Apply the brakes. Push on the product to make sure that the brakes work.
2. Lower the siderail (A) to the lowest position (Figure 6).
3. Raise the transfer board (C) from the bottom while you lift from the top.
N N o o t t e e - - The transfer board (C) is located between the siderail (A) and the mattress (B) (Figure 6).
4. Pivot the board downward onto the mating support surface.
5. Transfer the patient to the mating support surface.
1089-109-005 Rev AA.0 15 EN