Werbung
Verfügbare Sprachen
Verfügbare Sprachen
I I n n s s t t a a l l l l i i n n g g a a n n d d r r e e m m o o v v i i n n g g t t h h e e p p r r e e - - o o p p - - p p o o s s t t - - o o p p h h e e a a d d e e x x t t e e n n s s i i o o n n ( ( c c r r a a n n k k F F o o w w l l e e r r
b b a a c c k k r r e e s s t t o o n n l l y y ) )
1. To install the extension on the litter, slide the extension tube into the receptacle tube on the side of the Fowler frame.
Pivot the extension upward until the extension locks in place on the headpiece frame.
2. To remove the extension from the litter, pull the red knob (A) under the extension toward you (Figure 7). Rotate the
extension downward and pull the extension straight out of the socket.
N N o o t t e e
• The pre-op and post-op head extensions provide additional litter surface to protect the patient's head during
transport.
• The head extension can be used as push handles when you move the product.
P P o o s s i i t t i i o o n n i i n n g g t t h h e e w w r r i i s s t t r r e e s s t t
There are two optional wrist rests available:
•
Standard (1)
•
Temporal (2)
To position the wrist rest (Figure 8):
1. Insert the support tube (A) into the socket in the Fowler backrest head piece assembly.
2. Turn the knob (B) clockwise to secure the wrist rest assembly.
3. Turn the knob (C) counterclockwise to loosen it.
4. Raise or lower the wrist rest to the desired height.
5. Turn the knob clockwise to tighten the knob and hold the wrist rest in place.
N N o o t t e e - - The "U" shaped rest (D) can be pivoted up and away from the patient when the wrist rest is not in use.
1089-109-005 Rev AA.0
F F i i g g u u r r e e 7 7 – – R R e e d d k k n n o o b b l l o o c c a a t t i i o o n n
A
17
EN
Werbung
