Coltene BioSonic UC150 Benutzerhandbuch Seite 8
Vorschau ausblenden
Andere Handbücher für BioSonic UC150:
- Benutzerhandbuch (20 Seiten) ,
- Benutzerhandbuch (390 Seiten) ,
- Benutzerhandbuch (272 Seiten)
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5. Installation and Setup
General Setup
• Inspect the device for damage prior to setup. If the device is damaged, contact the distributor or
manufacturer.
• Select your desired location for the BioSonic UC150. It should be on a solid level surface and in
close proximity to a sink or to waste lines to facilitate draining. The hose supplied with the unit
will allow you to place the unit on the left side of the sink or connect directly to the waste line.
• Connect one end of the hose to the drain valve
If desired, have your plumber connect the hose directly to the waste line with the appropriate
fittings.
• CONNECT THE DISPLAY. Attach the connector on the bottom of the display module to the
connector on the top right-hand corner of the unit. Press the display module down carefully
until it snaps into the right position.
• PLUG IN THE UNIT. Attach the BioSonic UC150 electrical cord at the lower back of the unit and
plug into a three-wire grounded AC outlet (in accordance with local regulations)
is recommended that the unit be plugged into a Ground Fault Circuit Interrupter (GFCI) outlet.
Installation instructions for recessing unit:
• Tools Required:
- Electric Drill
- Drill bit to drill a hole large enough to accept your reciprocating saw blade
- Reciprocating saw and blade
NOTE: This BioSonic UC150 must be installed by an experienced equipment manager or licensed
contractor. Be sure to follow local building codes.
NOTE: Before you begin please read and understand the safety instructions provided by the
manufacturer of the tools required for installation.
• Select the desired location for the BioSonic UC150. You will need at least 19 cm (7.5 inches) clear
vertical space below the top of the counter to accommodate the tank enclosure. The countertop
must be flat and level. Make sure that you are not selecting a location which will interfere with
drawers or vertical partitions between cabinets.
*see last page for figures
8
(Figure 4*)
and place the other end in the sink.
(Figure
9*). It
Werbung
