KRAUSE ClimTec Bedienungsanleitung Seite 22

1. General
This application manual describes the correct assembly and dismantlement as well
as the usage of mobile aluminium scaffolds. It contains important safety instructions.
Carefully read all instructions in this document and familiarise yourself with the rele-
vant safety regulations.
Mobile Aluminium Scaffold is a modular system for which a range of optional acces-
sories is available. All available modules, including optional modules, are described in
this manual. Some of these modules might not be part of your system.
For certain uses, the system must be equipped with additional parts (e.g. ballast
weights) to ensure safety.
In order to enable you to decide whether you require such auxiliary parts, please read
all chapters of the manual.
The Scaffold-system can be equipped with an optional castor kit and thus upgraded
to a mobile working scaffold. Observe the special safety instructions that apply to this
option.
If you have any questions regarding the assembly, use or dismantling of the working
scaffold, please contact your supplier.
Subject to technical changes on the mobile working scaffold.
We will not assume liability for printers error of these Instructions for Assembly and
Use.
1.1 Responsibility of the operator
The operator of the working scaffold is responsible for the following:
– The Instructions for Assembly and Use have to be carried along in case of each
use as well as assembly, dismantling and rebuilding.
– The operating personnel has to be informed in detail about the contents and the
safety and hazard instructions and regulations of this manual and ensuring
compliance with these.
– All national and other applicable statutory regulations must be adhered to.
– The working scaffold may only be used for the purpose for which it is intended.
39
1.2 Manufacturer
Manufacturer of the described working scaffold:
KRAUSE-Werk GmbH & Co. KG
Am Kreuzweg 3
D 36304 Alsfeld
Telefon: +49 (0) 66 31 / 795-0
Telefax: +49 (0) 66 31 / 795-139
http://www.krause-systems.com
1.3 Applicable standards, type approval
The mobile aluminium scaffold corresponds to EN 1004.
The technical inspection was made by the TÜV PRODUKT SERVICE (Admission for
construction type).
1.4 Warranty
The warranty terms and conditions are included in the sales and delivery terms of the
supplier. Material defects are covered for 5 years from the date of purchase of the
affected part by the manufacturer's warranty. The manufacturer reserves the right to
replace or repair the defective part at its own choice.
The warranty is based on the installation and user manual valid on the day of
purchase of the product. Not covered by warranty are damages caused by any of the
following:
– Ignorance of or non-compliance with the instructions in the installation and user
manual and in particular with the safety instructions, instructions on proper and
improper use, maintenance and care instructions, and instructions for the erection
and dismantling of the scaffold.
– Use of the product by not qualified or insufficiently instructed personnel of the
operator.
– Use of spare and/or accessory parts from other suppliers than Krause.
– Use of damaged or defective component parts.
– Subject to technical changes.
– Extension of the working height by the use of ladders, boxes and other devices.
40