Bosch CS 3000 AWP Installations- Und Bedienungsanleitung Seite 65

User Menu query
Fig. 94
To display data only if multiple units are connected to the network:
If State Query is selected:
• Press or to select the unit's address and shown related
informations (only for units in modular configuration)
Fig. 95
• If TEMP QUERY is selected
Fig. 96
User menu - TIMER
• Press Menu
• Press Timer
• Select one of the 3 categories presented:
– If DAILY TIMER is selected the WEEKLY SCHEDULE cannot be
activated and vice versa
– If the unit is controlled via a remote ON/OFF or Modbus, DAILY
and WEEKLY timers are disabled
CS3000 AWP – 6721852570 (2022/11)
Fig. 97
TIMER menu - DAILY TIMER
• Press or to select timer 1 or timer 2
• When the cursor is over ACT press
• Select the start time, end time, mode, temperature to be set by press
or
• Press or to adjust the time, as well as the mode, and the
temperature value
• When the cursor is over SILENT MODE press
silent, standard, night silent or super silent modes
• Press OK to confirm or BACK to cancel
• The timer on symbol appears on the main screen
Fig. 98
Fig. 99
If two time slots overlap, the last one on the lists is activated (in figure
below - OFF)
Control unit
or to select ON/OFF
or to set the
65