Periodical Maintenance Checks; Reprocessing - NSK Primado2 Bedienungsanleitung

Periodical Maintenance Checks

9
Every three months, perform periodical maintenance checks on this product according to the following list. If any abnormalities are found,
contact your Authorized NSK Dealer.
Checking Item
Outer Surface
Each Connection Part
Attachment
Rotation

Reprocessing

10
Perform reprocessing appropriately according to OM-SZ0911MA Primado2 REPROCESSING MANUAL.
Description
Check for any scratches, damage or abnormalities on the outer surface.
Check for any scratches, damage or deformation of each connection part.
Connect the Attachment and check for abnormalities at the connection part.
After connecting each part, fasten the Twist Collet, close the Latch (Chuck Close position) and rotate the
Motor for approximately 1 minute by pressing the Foot Control Pedal or Hand Switch of the Motor. Check for
any abnormal vibration, noise or heat generation.
Check that the Motor stops normally after releasing the Foot Control Pedal or Hand Switch of the Motor.
50