Rectangularity Program („Squareness Programm"); Main Screen Of The Program; Measurement Process - Pce Instruments Pce-Tu 3 Bedienungsanleitung

Rectangularity program („Squareness programm")
8.4
This program is used to determine the rectangularity of two planes to each other. The rotatable laser
transmitter Rl-20 can emit laser beams in an exact angle of 90° with the help of its integrated Pentaprism.
The two rectangular laser beams are used as a reference. Four measurements shall be carried out – two
measurements on one plane and – after the direction of the laser beam was changed – two
measurements on the other plane. Place the rotatable laser transmitter in the corner between both
planes. Now you place the receiver (sensor M set by default) on the first position. Carry out rough
alignment, if necessary.
8.4.1

Main screen of the program

What should be noted in this window
All required dimensions should be entered
correctly (can be changed later on, if
recommended)
Functions in this window
- Enter dimensions
- Start measurement
- View results (available, if all required
measurements are finished)
- Save
Distance 1-2
8.4.2

Measurement process

Mark two points (near and far) on the first plane and repeat this action for the second plane. Press
and enter the distance between Point 1 and Point 2. Confirm pressing
between Point 3 and Point 4. Confirm again by pressing
corner between both planes and place the receiver on the first measurement point (far). Press
to get to the measurement screen.
Manual
. Place the rotatable laser transmitter in the
82
Shortcuts in this window
Start new measurement or
repeat measurement (all
collected data will be lost)
Enter dimensions
Save all data in one file (see
chapter 10 „Handling of the
Data Dialogue window")
Distance 3-4
and enter the distance
now,