Configuration Process; Carry Out Measurements; Duration Of The Connection Establishment - PCE Instruments PCE-TU 3 Bedienungsanleitung

8.3.6

Configuration process

To enter the number of points, press
Confirm the entry by pressing
field "Splice no." displays "-", there is only one part.
If the distances between all points ( in all splices) are the same, press
Distances" checkbox. Press
. The entered value is used for all distances, if the checkbox "Equal Distances" is activated.
pressing
If the distances between the points are not equal, use
enter the distance to the next point. Repeat the process for all points (except for the last one).
Note: If you use more splices, check the splice number displayed at "Splice no.", to check in which part
you are currently situated. The distance between two overlap points cannot be edited.
To add a new splice, press
"2"). Configure the new splice after that.
If you want to change parameters, press
activate/deactivate the manual data entry by pressing
Pressing makes it possible to switch between the measurement units mm and inch. Press
to use the sensor S as your aim and press
, enter a probe number and confirm by pressing
menu.
8.3.7

Carry out measurements

Press in the main screen of the program, to get to the measurement screen.
What should be noted in this window
Carry out rough alignment of the laser,
when you start a new measurement
Functions in this window
- Carry out measurement
- Enter data manually (if activated)
8.3.8

Duration of the connection establishment

Depending on which interface is used to connect the sensors (Bluetooth or serial), the connection
establishment can take between 2 and 30-40 seconds. It is recommended to wait about 10 seconds
(cable connection) or about 50 seconds (wireless connection). If no connection is established after that
time, check the sensors and the system settings of the PCE-TU 3.
Manual
and enter the desired value (3 up to 300 points are possible).
. Make sure, that all points are placed on the current part (splice). If the
now, to reach the field of distance entry, enter a value and confirm by
and add "1" to the current "Splice no." (if the current value is "-", enter
, to reach the parameter screen. Here you can
, if you want to use an external laser. For averaging, press
76
and activate the "Equal
and , to select a point and press
or the manual angle entry by pressing
.. Press to save and exit the parameter
Shortcuts in this window
Delete measurement point
Manual entry of detector value
(V)
Manual entry of detector value
(H)
Change measurement units
Open context menu
Navigate forward/backward
through the points
, to
.
,