Vertical Machine Alignment - Pce Instruments Pce-Tu 3 Bedienungsanleitung

Thickness of the front
machine base
Thickness of the rear
machine base
Remaining misalignment
7.2

Vertical machine alignment

Mount the measurement sensor, marked as S, to the shaft of the stationary machine and the
measurement sensor marked as M to the moveable machine.
Note: Mark the 3, 6, 9 and 12 o'clock position on the machine housing.
Connect the cable as described in chapter 5.3 "Connection of the measurement sensors" or configure
the Bluetooth-interface (only with optional Bluetooth adaptor).
What should be noticed in this window
Check the result after the alignment,
by measurement again
Functions in this window
- Determine new data and start the
alignment
- Continue the alignment
- Change parameters
- Change dimensions and distances
- View/change
Manual
Shortcuts in this window
Determine new data
Continue alignment process
Change the machine dimensions and distances
Add/change parameters
28
Measurement
unit