Configuration Process - Pce Instruments Pce-Tu 3 Bedienungsanleitung

Orange colour marks
selected distance
Hole Diameter
Start new measurement
All data will be deleted
8.2.3

Configuration process

Enter the amount of planes (holes) by pressing
should be between 3 and 300). If the planes to be measured are arranged with the same distance one to
the other, activate the "Equal Distances" function by pressing
and enter the distance. If the distances between the planes are not equal, they you can select single
planes with the help of
three measurement points for the plane (not recommended), it makes sense to enter the hole diameter
for the particular plane. To do that, press
want to change parameters, press
the manual data entry by pressing
can switch between the measurement units mm and inch. Press
, if you want to use an external laser. For averaging, press
confirm pressing
and and enter the particular distances with
, to get to the parameter screen. Here, you can activate/deactivate
or the manual angle entry by pressing
. In order to save and leave the parameter menu, press
Manual
Shows the number of the
selected plane and the
number of the next plane
Number of the plane you
can enter the diameter for
and entering the value to the entering field (value
and hooking the checkbox. Press
and enter the particular value for the current plane. If you
, to use sensor S as your aim and
69
Number of planes
Checkbox
Current hole/plane
distance
. If you only want to use
. By pressing
, enter your sample number and
, you