Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5.2
System setup
Before working with the Shaft alignment tool, you need to control the battery status, and recharge the
battery, if necessary.
The battery status is displayed as a small, coloured figure on the bottom of the main menu of the
instrument, while the exact battery status is available in the menu item "Setup".
Check and clean the surface of the laser detector and the exit hole of the sensor, if necessary.
Use a cotton pad soaked in alcohol for the cleaning. Do not use solvents for the cleaning under any
circumstances.
Check date and time of the system clock and adjust them, if necessary.
5.3
Connection of the measurement sensors
There are serial ports on the display unit, as well as on the measurement sensors. The sensors need to
be connected in series to the display unit with the enclosed cables. Refer to the following figure
Serial connection of the sensors
Manual
11
Werbung
Inhaltsverzeichnis
