Carry Out Measurement; Duration Of The Connection Establishment - Pce Instruments Pce-Tu 3 Bedienungsanleitung

8.2.4

Carry out measurement

Press in the main screen of the program and the measurement screen will appear.
What should be noted in this window
Carry out a rough alignment of the laser,
if you want to start a new measurement.
Functions in this window
- Carry out measurement
- Manual data entry (if activated)
- Manual angle entry (if activated)
8.2.5

Duration of the connection establishment

Depending on which interface is used to connect the sensors (Bluetooth or serial), the connection
establishment can take between 2 and 30-40 seconds. It is recommended to wait about 10 seconds
(cable connection) or about 50 seconds (wireless connection). If no connection is established after that
time, check the sensors and the system settings of the PCE-TU 3.
Laser beam is out of
aiming conditions
Current plane number
Laser beam position
indication
Amount of saved
measurements in the
current plane
Current result (Y-axis)
Current result (X-axis)
Standard deviation (is
zero until more than 5
measurements have
been saved)
Manual
Not ready (wait)
‚/3' means the current saved measurement (3)
and ‚->4' means ready to save measurements
(4) (accessible via
70
Shortcuts in this window
Delete the measurement points
of the current plane (all saved
values will be lost)
Manual entry of the detector
value
Manual angle entry
Switch measurement unit
Open context menu
Navigate forwards/backwards
through the planes
Navigate through measurement
No connection to the
sensors
Neigungs-
anzeige
)
Current measurement
point number.
„-„ means no
measurement
Detector value, „-.---„
means no data
Receiver inclination in
degrees.
„- -„ means no data
Saved measurement
points are displayed
here
Saved measurement
point
Inclication of the
saved measurement
point