8.1.10 View And Save Results; 8.1.11 Reference Modes - Pce Instruments Pce-Tu 3 Bedienungsanleitung

8.1.10 View and save results

For a better understanding, the measurement results are displayed as a grid, where the relative position
of the individual items is graphically displayed. Each point is displayed as a coloured circle or as a
colouered triangle (triangle = reference point) and is equipped with „+", „-„ or 0.
„+" indicates above and „-„ indicates beneath the reference plane.
indicates "excellent"(tolerance <25%)
The blue colour
indicates "good" (tolerance < 50%)
The green colour
indicates "warning" (tolerance <100%)
The yellow colour
indicates "bad" (tolerance < 50%)
The red colour
The headline of the screen shows the coordinates and the measurement value of the selected point. The
value depends on the selected mode.
Coordinates of
the point
[line:column]
Y-axis position
of the point
Displacement
of the point
Tolerance
value (here
0,74)

8.1.11 Reference modes

There are three reference modes, you can select between by pressing
8.1.11.1 No reference plane
The result is an unchanged receiver value
8.1.11.2 Laser Plane
If no reference points are defined, the result is an unchanged receiver value, if three reference points are
defined, the result is the difference between the calculated three-point-reference plane and the receiver
value.
8.1.11.3 Best-Fit Plane
The result is the difference between the calculated Best-Fit-Plane and the receiver value.
Manual
Measurement
Data for the point are
result of the
available (was not
point
Change
reference plane
save
Back to data
acquisition
64
X-axis position
of the point
skipped)
Reference point
(if selected)
View statistics
Define/reset
reference point
Change value
.
change
Edit point
mode