Soft Foot Measurement - Pce Instruments Pce-Tu 3 Bedienungsanleitung

7.3

Soft Foot Measurement

What should be noted in this window
The machine dimensions should be entered first
(go to the according menu item)
Functions in this window
- Perform Soft Foot Measurements for all
machine feet
Firstly enter the machine dimensions (just as described with the horizontal alignment) or skip the process
by pressing and go to the sensor aiming screen.
If the laser beams are aligned and you leave the sensor aiming screen, you get to the Soft Foot
Measurement screen.
Now go through the following steps for every single machine base:
- Loosen the mounting (placed on the red square) of the required machine base, wait for 5
seconds and press
base and press
Manual
to store the value. Having done that, you need to remount the machine
, to continue with the next base.
40
Shortcuts in this window
Start the Soft Foot Measurement.
Rotate the sensors to the 12 o'clock
position and adjust the laser until it
aims the target plate S and M in the
middle.
Restart the Soft Foot Measurement
Save results to a file (see chapter 10
"Handling of the Data Dialogue
window")