Main Screen Of The Spindle Program; Measurement Process; Carry Out Measurement - Pce Instruments Pce-Tu 3 Bedienungsanleitung

7.6.1

Main screen of the Spindle Program

What should be noted in this window
The needed dimensions should be entered
correctly (can be changed later on, if
recommended).
Functions in this window
- Enter dimensions
- Start measurement
- View measurement results (available, if all needed
measurements are finished)
- Save
7.6.2

Measurement process

Mark two points on the machine bed (near and far), where the receiver shall be placed on the tool slide
for future measurement.
Enter the distance between the near and the far measurement point. Mount the transmitter to the spindle
and the receiver to the tool slide. You can carry out a rough alignment, if needed. Press
measurement screen.
7.6.3

Carry out measurement

Press , to carry out a measurement. Use
Press , to return to the former screen
Transmitter label
position (here: top)
Inclinator of the
receiver
Laser beam position
indicator
Manual
and
Blinking blue means
the currently selected
point
Measurement data
not ready (wait)
48
Shortcuts in this window
Start new measurement or
restart measurement (all
acquired data will be lost)
Enter the amount of
measurement points (positions)
Enter the distance between the
measurement points (near and
far)
Save results to a file (see
chapter 10 "Handling of the
Data Dialogue window")
, to switch between the measurement points.
Saved measurement
value „-,--„ means that no
value is saved
Distance between the
measurement points
Means no possible
connection to the
Laser beam out of
the aim
, to get to the
sensors