Braun Welch Allyn Thermoscan PRO 6000 Gebrauchsanweisung Seite 24


Remove the thermometer from the dock and clean the metal
electrical contacts on the thermometer.

Place the thermometer aside for 1 minute, allowing the contacts
to air dry.
Note: If any cleaning agent, other than isopropyl or ethyl alcohol, comes into contact with
the probe, probe lens window or contacts immediately wipe dry. Then clean the probe, probe
lens window and contacts with isopropyl or ethyl alcohol.
14.2 Cleaning the thermometer body and cradle
Do not submerge the thermometer. Excess liquid may cause damage to the thermometer.
Wipes should be moist, not saturated.
Do not use any chemical other than those listed in the Approved Cleaning Solution Table to clean
the thermometer body and cradle. Other cleaning agents could cause damage to the thermometer.
When cleaning the probe lens window or probe ONLY use isopropyl or ethyl alcohol.
Do not use abrasives pads or cleaners.
1 MINUTE
23