Braun Welch Allyn Thermoscan PRO 6000 Gebrauchsanweisung Seite 21

Error message
or
13. PerfecTemp™ status
Error message
Situation
System error
(All icons display or display
is blank)
If error persists,
If error still persists,
If error still persists,
Battery is low, but thermometer
will still operate correctly.
Battery is too low to allow
temperature measurement.
Do you have any further
questions?
Situation
PerfecTemp™ sensor system is
not functioning or disabled.
U is "Unadjusted Operating
Mode". Mode used for raw
temperature measurement.
Requires service tool access to
enable.
Solution
Wait 20 seconds until the
thermometer turns off
automatically, then turn on again.
... reset the thermometer by
removing the batteries and
putting them back in.
... batteries are dead. Insert new
batteries.
... contact local Welch Allyn
Service Center or representative.
Insert new batteries.
Insert new batteries.
... contact local Welch Allyn
Service Center or representative.
Solution
... contact local Welch Allyn
Service Center or representative.
See 11.3 Advanced function
settings and adjust settings
via Service Tool or contact local
Welch Allyn Service Center or
representative.
R
a
p
RECHARGA
and ashing
prompt user
20