Braun Welch Allyn Thermoscan PRO 6000 Gebrauchsanweisung Seite 29


Remove the batteries and replace with new batteries, making
sure the poles are in the right direction.

Snap battery door back into place and ensure the latch returns
to original latch position.
This product contains batteries and recyclable electronic waste.
To protect the environment, do not dispose of it in the trash,
but take it to appropriate local collection points according to
national or local regulations.
14.8 Calibration testing
The thermometer is initially calibrated at the time of manufacture. If the thermometer is used
according to the use instruction, periodic readjustment is not required. However, Welch Allyn
recommends checking calibration on an annual basis or whenever clinical accuracy of the
thermometer is in question. Procedures for checking calibration are outlined in the 9600 Plus
Calibration Tester (REF 01802‑110) directions for use manual.
The above recommendations do not supersede the legal requirements. The user must always
comply with legal requirements for the control of the measurement, functionality, and accuracy of
the device which are required by the scope of relevant laws, directives or ordinances where the
device is used.
28