Bosch BPT-C 200 Betriebsanleitung Seite 173

English
Procedures
15. Check the external fuse for the
power connection
16. Check the LED indicators in the
control cabinet
17. Inspect the coupling relays
18. Measure the AC voltage, i.e.
phase to phase and phase to PE
19. Measure the auxiliary power
supply
20. Measure the solar generator
voltage (DC)
21. Check the polarity of the DC
connection
22. Measure the earthing
resistance. Please note the
following here: Operating manual
of the measuring equipment
23. Check the grid characteristics
24. Check all protective covers
Bosch Power Tec GmbH
Desired result
450 A (level of performance 200
kVA), 630 A (level of performance
300 kVA): gG or circuit breaker
722 A (level of performance 350
kVA) gG, gTr or circuit breaker
LED indicators of the power
supply, the buffer module and the
PCB light up green.
The coupling relays are snapped in
place.
(Technical specifications, p. 83)
(Technical specifications, p. 83)
530–1000 V (levels of
performance 200 kVA and
300 kVA)
580–1000 V (level of performance
350 kVA)
RA < 2 Ω
RA ≤ UL/IF
Grid characteristics meet the
energy supplier's specifications.
All protective covers are fitted and
screwed into place.
Actual result/assessment
Commissioning report | 81
Action in case of non-compliance
– Replace the fuses
– When using a circuit breaker, set it
to the rated current of the device
– Contact the manufacturer
(contact details on the back of the
manual).
– Snap the coupling relays in place
– Inspect the installation
– Check the AC grid
– Inspect the installation
– Check the AC grid
– Inspect the installation
– Check the solar generator
– Inspect the installation
– Check the solar generator
– Checking the earthing
– Change the grid characteristics
appropriately
– Fit protective covers and screw
into place
BPT-C 200, 300, 350 | Operating manual