Recaro Seat; Control Panel; Lower Position Mounting - Otto Bock B 600 Bedienungsanleitung

Options
12.7

Recaro Seat

The B600 power wheelchair can be equipped with different Recaro seat models.
The turning handle on the right or left side of the backrest is used to adjust the back
angle.
To fold down the backrest, a release handle is used, which is located laterally at the
backrest. By pulling the release handle upward, the backrest can be folded down to
the front.
The Recaro seat can be equipped with an electric back angle adjustment. To control
the electric back angle adjustment, the menu "Additional functions" of the wheelchair
control is used.
The Recaro seat can easily be removed from the chassis.
Way of proceeding:
- Pull at the release strap which is located below the anterior part of the seat bottom.
- Loosen the two locking bolts which lock the seat to the right and left seat frame.
- To release the posterior seat attachment from the retainer bushings, slightly tilt the
seat to the rear and slide back a little.
- Remove the Recaro seat.
- Now you have free access for any maintenance work.
- For remounting, place the posterior edge of the Recaro seat on the end of the seat
frame.
- Slide the seat forwards until the seat hangs in the posterior retainer bushings.
- Tilt the seat to the front until the locking bolts engage with the seat frame.
12.8

Control Panel

12.8.1 Lower Position Mounting

A special control panel holder can be mounted as an option allowing the control panel
to be mounted and adjusted downwards.
To do this, loosen the attachment screw (fig. 32) and adapt the height of the control
panel and joystick height to the armrest.
84
Note!
Make sure that the backrest firmly locks in place!
Attention!
Make sure when mounting the Recaro seat, that the seat is
securely attached to the retainer bushings and that the anterior
locking bolts have engaged up to the key ring!
B600 – Instructions for Use